- 您現在的位置：買賣IC網 > PDF目錄379610 > AD408M328RTB-5 (Electronic Theatre Controls, Inc.) Low voltage operation is more suitable to be used on battery backup, portable electronic PDF資料下載
參數資料
| 型號： | AD408M328RTB-5 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | Low voltage operation is more suitable to be used on battery backup, portable electronic |
| 中文描述： | 低電壓操作更適合于備用電池，使用便攜式電子 |
| 文件頁數： | 14/28頁 |
| 文件大小： | 211K |
| 代理商： | AD408M328RTB-5 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
Rev.1
Page 14
Notes :
1. AC measurements assume t
T
= 2ns.
2. An initial pause of 100
is required after power up, and it followed by a minimum of eight
initialization cycles (RAS - only refresh cycle or CAS - before - RAS refresh cycle). If the internal
refresh counter is used, a minimun of eight CAS - before - RAS refresh cycles are required.
3. In delayed write or read-modify-write cycles, OE must disable output buffer prior to applying data to
the device.
4. All the V
CC
and V
SS
pins shall be supplied with the same voltages.
5. t
RAS
(min) = t
RWD
(min)+t
RWL
(min)+t
T
in read-modify-write cycle.
6. t
CAS
(min) = t
CWD
(min)+t
CWL
(min)+t
T
in read-modify-write cycle.
7. t
ASC
(min), t
RCS
(min), t
WCS
(min), and t
RPC
are determined by the falling edge of CAS .
8. t
RCD
(max) is specified as a reference point only, and t
RAC
(max) can be met with the t
RCD
(max) limit.
Otherwise, t
RAC
is controlled exclusively by t
CAC
if t
RCD
is greater than the specified t
RCD
(max) limit.
9. t
RAD
(max) is specified as a reference point only, and t
RAC
(max) can be met with the t
RAD
(max) limit.
Otherwise, t
RAC
is controlled exclusively by t
AA
if t
RAD
is greater than the specified t
RAD
(max) limit.
10. t
CRP
, t
CHR
, t
RCH
, t
CPA
and t
CPW
are determined by the rising edge of CAS .
11. V
IH
(min) and V
IL
(max) are reference levels for measuring timing or input signals. Therefore, transition
time is measured between V
IH
and V
IL
.
12. Assumes that t
RCD
t
RCD
(max) and t
RAD
t
RAD
(max). If t
RCD
or t
RAD
is greater than the maximum
recommended value shown in this table, t
RAC
exceeds the value shown.
≥
13. Assumes that
(max) and
(max).
14. Access time is determined by the maximum of t
AA
, t
CAC
, t
CPA
.
15. Assumes that
(max) and
(max).
16. Either t
RCH
or t
RRH
must be satisfied for a read cycle.
17. t
OFF
(max) and t
OEZ
(max) define the time at which the output achieves the open circuit condition (high
impedance). t
OFF
is determined by the later rising edge of RAS or CAS.
18. t
WCS
, t
RWD
, t
CWD
, and t
AWD
are not restrictive operating parameters. They are included in the data
sheet as electrical characteristics only. If
(min), the cycle is an early write cycle and the
data out will remain open circuit (high impedance) throughout the entire cycle. If
(min),
(min),
(min) and
(min), the cycle is a read-modify-write and
the data output will contain data read from the selected cell. If neither of the above sets of conditions
is satisfied, the condition of the data output (at access time) is indeterminate.
19. These parameters are referenced to CAS separately in an early write cycle and to WE edge in a
delayed write or a read-modify-write cycle.
20. t
RASP
defines RAS pulse width in EDO page mode cycles.
μ
s
≤
≤
t
RCD
t
RCD
t
RAD
t
RAD
≤
t
RCD
t
RCD
≤
t
RAD
t
RAD
≥
t
WCS
t
WCS
≥
t
RWD
t
RWD
≥
t
CWD
t
CWD
≥
t
AWD
t
AWD
≥
t
CPW
t
CPW
≥
相關PDF資料 |
PDF描述 |
|---|---|
| AD408M328VBB-5 | Low voltage operation is more suitable to be used on battery backup, portable electronic |
| AD408M328VCA-5 | Low voltage operation is more suitable to be used on battery backup, portable electronic |
| AD408M328VCB-5 | Low voltage operation is more suitable to be used on battery backup, portable electronic |
| AD408M328VLA-5 | Low voltage operation is more suitable to be used on battery backup, portable electronic |
| AD408M328VLB-5 | Low voltage operation is more suitable to be used on battery backup, portable electronic |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD40906 | 制造商:Analog Devices 功能描述: |
| AD40970 | 制造商:Analog Devices 功能描述: |
| AD40993 | 制造商:Analog Devices 功能描述: |
| AD40A | 功能描述:鉗型萬用表及配件 MINI-CLAMP AMMETER RoHS:否 制造商:Fluke 準確性:2 % 測距:400 A |
| AD40A/DM73B | 功能描述:函數發生器與合成器 ELECTRICAL COMBO KIT RoHS:否 制造商:Tektronix 頻率:20 MHz 設備類型:Function Generators |
發布緊急采購，3分鐘左右您將得到回復。