- 您現在的位置：買賣IC網 > PDF目錄361037 > LMC6484IN (NATIONAL SEMICONDUCTOR CORP) CMOS Quad Rail-to-Rail Input and Output Operational Amplifier PDF資料下載
參數資料
| 型號： | LMC6484IN |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 運算放大器 |
| 英文描述： | CMOS Quad Rail-to-Rail Input and Output Operational Amplifier |
| 中文描述： | QUAD OP-AMP, 3700 uV OFFSET-MAX, 1.5 MHz BAND WIDTH, PDIP14 |
| 封裝： | DIP-14 |
| 文件頁數： | 12/22頁 |
| 文件大小： | 973K |
| 代理商： | LMC6484IN |
Typical Performance Characteristics
V
S
= +15V, Single Supply, T
A
= 25C unless otherwise
specified (Continued)
Application Information
1.0 Amplifier Topology
The
LMC6484
wide-compliance range current mirrors and the body effect to
extend input common mode range to each supply rail.
Complementary paralleled differential input stages, like the
type used in other CMOS and bipolar rail-to-rail input ampli-
fiers, were not used because of their inherent accuracy prob-
lems due to CMRR, cross-over distortion, and open-loop
gain variation.
The LMC6484’s input stage design is complemented by an
output stage capable of rail-to-rail output swing even when
driving a large load. Rail-to-rail output swing is obtained by
taking the output directly from the internal integrator instead
of an output buffer stage.
incorporates
specially
designed
2.0 Input Common-Mode Voltage Range
Unlike Bi-FET amplifier designs, the LMC6484 does not ex-
hibit phase inversion when an input voltage exceeds the
negative supply voltage. Figure 1shows an input voltage ex-
ceeding both supplies with no resulting phase inversion on
the output.
The absolute maximum input voltage is 300 mV beyond ei-
ther supply rail at room temperature. Voltages greatly ex-
ceeding this absolute maximum rating, as in Figure 2 can
cause excessive current to flow in or out of the input pins
possibly affecting reliability.
Applications that exceed this rating must externally limit the
maximum input current to
±
5 mA with an input resistor as
shown in Figure 3
3.0 Rail-To-Rail Output
The approximated output resistance of the LMC6484 is
180
sourcing and 130
sinking at V
= 3V and 110
sourcing and 83
sinking at V
= 5V. Using the calculated
output resistance, maximum output voltage swing can be es-
timated as a function of load.
4.0 Capacitive Load Tolerance
The LMC6484 can typically directly drive a 100 pF load with
V
= 15V at unity gain without oscillating. The unity gain fol-
lower is the most sensitive configuration. Direct capacitive
Stability vs
Capacitive Load
DS011714-89
Stability vs
Capacitive Load
DS011714-90
DS011714-10
FIGURE 1. An Input Voltage Signal Exceeds the
LMC6484 Power Supply Voltages with
No Output Phase Inversion
DS011714-12
FIGURE 2. A
±
7.5V Input Signal Greatly
Exceeds the 3V Supply in
Figure 3
Causing
No Phase Inversion Due to R
I
DS011714-11
FIGURE 3. R
Input Current Protection for
Voltages Exceeding the Supply Voltage
www.national.com
12
相關PDF資料 |
PDF描述 |
|---|---|
| LMC6484MN | CMOS Quad Rail-to-Rail Input and Output Operational Amplifier |
| LMC6484 | CMOS Quad Rail-to-Rail Input and Output Operational Amplifier |
| LMC6484AIM | CMOS Quad Rail-to-Rail Input and Output Operational Amplifier |
| LMC6572 | Low Voltage (2.7V and 3V) Operational Amplifier |
| LMC6572AIM | Low Voltage (2.7V and 3V) Operational Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LMC6484IN | 制造商:Texas Instruments 功能描述:IC OP AMP QUAD CMOS 6484 DIP14 |
| LMC6484IN/NOPB | 功能描述:運算放大器 - 運放 CMOS Quad R/R I/O Op Amp RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| LMC6484MN | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:CMOS Quad Rail-to-Rail Input and Output Operational Amplifier |
| LMC6484N | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:CMOS Quad Rail-to-Rail Input and Output Operational Amplifier(970.84 k) |
| LMC6492 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:CMOS Rail-to-Rail Input and Output Operational Amplifier |
發布緊急采購，3分鐘左右您將得到回復。