- 您現在的位置：買賣IC網 > PDF目錄363883 > W39V040FAT (WINBOND ELECTRONICS CORP) 512K X 8 CMOS FLASH MEMORY WITH FWH INERFACE PDF資料下載
參數資料
| 型號： | W39V040FAT |
| 廠商： | WINBOND ELECTRONICS CORP |
| 元件分類： | PROM |
| 英文描述： | 512K X 8 CMOS FLASH MEMORY WITH FWH INERFACE |
| 中文描述： | 512K X 8 FLASH 3.3V PROM, 11 ns, PDSO40 |
| 封裝： | 10 X 20 MM, TSOP-40 |
| 文件頁數： | 5/36頁 |
| 文件大小： | 518K |
| 代理商： | W39V040FAT |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
W39V040FA
Publication Release Date: December 19, 2002
- 5 -
Revision A2
Hardware Data Protection
The integrity of the data stored in the W39V040FA is also hardware protected in the following ways:
(1) Noise/Glitch Protection: A #WE pulse of less than 15 nS in duration will not initiate a write cycle.
(2) V
DD
Power Up/Down Detection: The programming and read operation are inhibited when V
DD
is
less than 1.5V typical.
(3) Write Inhibit Mode: Forcing #OE low or #WE high will inhibit the write operation. This prevents
inadvertent writes during power-up or power-down periods.
(4) V
DD
power-on delay: When V
DD
has reached its sense level, the device will automatically time-out
5 mS before any write (erase/program) operation.
Data Polling (DQ
7
)- Write Status Detection
The W39V040FA includes a data polling feature to indicate the end of a program or erase cycle.
When the W39V040FA is in the internal program or erase cycle, any attempts to read DQ
7
of the last
byte loaded will receive the complement of the true data. Once the program or erase cycle is
completed, DQ
7
will show the true data. Note that DQ
7
will show logical "0" during the erase cycle,
and when erase cycle has been completed it becomes logical "1" or true data.
Toggle Bit (DQ
6
)- Write Status Detection
In addition to data polling, the W39V040FA provides another method for determining the end of a
program cycle. During the internal program or erase cycle, any consecutive attempts to read DQ
6
will
produce alternating 0's and 1's. When the program or erase cycle is completed, this toggling between
0's and 1's will stop. The device is then ready for the next operation.
Register
There are three kinds of registers on this device, the General Purpose Input Registers, the Block Lock
Control Registers and Product Identification Registers. Users can access these registers through
respective address in the 4Gbytes memory map. There are detail descriptions in the sections below.
General Purpose Inputs Register
This register reads the FGPI[4:0] pins on the W39V040FA.This is a pass-through register which can
read via memory address FFBC0100(hex). Since it is pass-through register, there is no default value.
GPI Register Table
BIT
7
5
4
3
2
1
0
FUNCTION
Reserved
Read FGPI4 pin status
Read FGPI3 pin status
Read FGPI2 pin status
Read FGPI1 pin status
Read FGPI0 pin status
相關PDF資料 |
PDF描述 |
|---|---|
| W39V040FB | 512K X 8 CMOS FLASH MEMORY WITH FWH INTERFACE |
| W39V040FBP | 512K X 8 CMOS FLASH MEMORY WITH FWH INTERFACE |
| W39V040FBPZ | 512K X 8 CMOS FLASH MEMORY WITH FWH INTERFACE |
| W39V040FBQ | 512K X 8 CMOS FLASH MEMORY WITH FWH INTERFACE |
| W39V040FBQZ | 512K X 8 CMOS FLASH MEMORY WITH FWH INTERFACE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W39V040FB | 制造商:WINBOND 制造商全稱:Winbond 功能描述:512K X 8 CMOS FLASH MEMORY WITH FWH INTERFACE |
| W39V040FB_07 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:512K × 8 CMOS FLASH MEMORY WITH FWH INTERFACE |
| W39V040FBP | 制造商:WINBOND 制造商全稱:Winbond 功能描述:512K X 8 CMOS FLASH MEMORY WITH FWH INTERFACE |
| W39V040FBPZ | 制造商:WINBOND 制造商全稱:Winbond 功能描述:512K X 8 CMOS FLASH MEMORY WITH FWH INTERFACE |
| W39V040FBQ | 制造商:WINBOND 制造商全稱:Winbond 功能描述:512K X 8 CMOS FLASH MEMORY WITH FWH INTERFACE |
發布緊急采購，3分鐘左右您將得到回復。