- 您現在的位置：買賣IC網 > PDF目錄363893 > W65C02S8Q-14 (Electronic Theatre Controls, Inc.) Microprocessor PDF資料下載
參數資料
| 型號： | W65C02S8Q-14 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | Microprocessor |
| 中文描述： | 微處理器 |
| 文件頁數： | 10/40頁 |
| 文件大小： | 1011K |
| 代理商： | W65C02S8Q-14 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
The Western Design Center, Inc.
W65C02S Data Sheet
The Western Design Center, Inc. W65C02S Data Sheet
10
3.7
No Connect (NC)
The No Connect (NC) pins are not connected internally and should not be connected externally.
3.8
Phase 2 In (PHI2), Phase 2 Out (PHI2O) and Phase 1 Out (PHI1O)
Phase 2 In (PHI2) is the system clock input to the microprocessor internal clock. During the low power Standby
Mode, PHI2 can be held in either high or low state to preserve the contents of internal registers since the
microprocessor is a fully static design. The Phase 2 Out (PHI2O) signal is generated from PHI2. Phase 1 Out
(PHI1O) is the inverted PHI2 signal. An external oscillator is recommended for driving PHI2 and used for the main
system clock. All production test timing is based on PHI2. PHI2O and PHI1O were used in older systems for
system timing and internal oscillators when an external crystal was used.
3.9
Read/Write (RWB)
The Read/Write (RWB) output signal is used to control data transfer. When in the high state, the microprocessor is
reading data from memory or I/O. When in the low state, the Data Bus contains valid data to be written from the
microprocessor and stored at the addressed memory or I/O location. The RWB signal is set to the high impedance
state when Bus Enable (BE) is low.
3.10
Ready (RDY)
A low input logic level on the Ready (RDY) will halt the microprocessor in its current state. Returning RDY to the
high state allows the microprocessor to continue operation following the next PHI2 negative transition. This bi-
directional signal allows the user to single-cycle the microprocessor on all cycles including write cycles. A negative
transition to the low state prior to the falling edge of PHI2 will halt the microprocessor with the output address lines
reflecting the current address being fetched. This assumes the processor setup time is met. This condition will
remain through a subsequent PHI2 in which the ready signal is low. This feature allows microprocessor interfacing
with low-speed memory as well as direct memory access (DMA). The WAI instruction pulls RDY low signaling the
WAit-for-Interrupt condition, thus RDY is a bi-directional pin. On the W65C02 hard core there is a WAIT output
signal that can be used in ASIC's thus removing the bi-directional signal and RDY becomes only the input. In such
a situation the WAI instruction will pull WAIT low and must be used external of the core to pull RDY low or the
processor will continue as if the WAI never happened. The microprocessor will be released when RDY is high and
a falling edge of PHI2 occurs. This again assumes the processor control setup time is met. The RDY pin has an
active pull-up, when outputting a low level, the pull-up is disabled. The RDY pin can still be wire ORed.
相關PDF資料 |
PDF描述 |
|---|---|
| W65C02SP-14 | Microprocessor |
| W65C02SPL-14 | Microprocessor |
| W65C02SQ-14 | Microprocessor |
| W65C816S | Microprocessor |
| W6612 | Dual PCM Codec(雙通道PCM編解碼器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W65C02SP-14 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microprocessor |
| W65C02SPL-14 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microprocessor |
| W65C02SQ-14 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microprocessor |
| W65C134S8PL-8 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller |
| W65C134S8PLG-14 | 制造商:Western Design Center (WDC) 功能描述:8-bit Microcontrollers - MCU 8-bit Microcontroller |
發布緊急采購，3分鐘左右您將得到回復。